Thanks I'll give them a shot. You have them for the front turn signals without any resistor?
Yes, no issues or codes here is the link. Again search eBay for what you need and just add "lasfit" before or after the blub you are looking to exchange.
Link front blinker no error: https://www.ebay.com/itm/LASFIT-7443...t/123474473039
Used these same CANBUS blinkers on my wife Tahoe they are always on turn signal blub so they actually shine white while always on then switch to amber when we turn. Top notch stuff, will give you before and after of the taillight install. No, need for a resistor for the front turn signal on the compass, but the back is a different story as you don't want a yellow light although it is just white 7443 blub. I got a red LED 7443, tried to install without resistor but no dice. Links below on what I am going to do 2nd install with. Doing the reverse, I did not get a resistor for the backup bulb as it doesn't blink it is an on and off only. Will update with before and after pics and if the reverse white LED needs resistor as well. Links for all I used below.
Red LED brake/blinker rear: https://www.ebay.com/itm/LASFIT-7443...7/323412537345
Resistor they recommended: https://www.ebay.com/itm/2pc-Canbus-...3/122910818667
White LED reverse blub: https://www.ebay.com/itm/LASFIT-7440...6/122852812612
T10 side indicator: https://www.ebay.com/itm/LASFIT-T10-...b/123004561458
I also did my inside swap to LED a while back with some generic china white LED on eBay... was ok with them they were not the best and left a glow. Thought that was normal, but found out that is due to crap LED's. Picked up their's and they are expensive, but I needed some for the Tahoe anyway. They are so much brighter it is shocking..... I left the dome ones in of the old china ones, will do before and after shots(and the license plate area as well). No afterglow either anymore!
White T10: https://www.ebay.com/itm/LASFIT-T10-...e/123043426833
These LED's are not bargain prices, but dam they are good LED's!
Anyway does anyone have DRL LED's that won't glow? Mine glow... I need to bump this china junk... I will do Lasfit product but wanted to see other options from other people.
will post pics when I do the conversion.
Originally Posted by RadRacer
IronWalls are garbage. Fitment issues in the factory housings, then they scattered light like crazy once I did get them in. And they put out less light than the factory bulbs.
Link? I am thinking of trying doing cheap LED yellows for my fog lights. I have cheap white LED's in the fogs now... but the low beams throw light all over can't tell if the white fogs are even doing anything. So I am going yellow
Did they work in high beams? Have you seen my post in jeep compass modification area? Little of a cluster right now but looking at getting these and they are moving them to work with my compass or our compasses that have reflector housing. I will keep an update here and there on what happens to that mod. eBay and PayPal have me covered if things go south.
That was a post haha!