| Topic Review (Newest First) |
| 05-29-2014 11:25 PM | |
| tripplec |
Quote:
Originally Posted by wojeda
View Post
Last 4 months a change twice the outer tie rods and once the inner rods. I think because the part were too cheap, or had a problem in.
In looking for a mevotech or mopar (need to be imported from US). I will try to do it myself. Regards,  |
| 05-22-2014 05:59 PM | |
| wojeda |
Last 4 months a change twice the outer tie rods and once the inner rods. I think because the part were too cheap, or had a problem in. In looking for a mevotech or mopar (need to be imported from US). I will try to do it myself. Regards,
|
| 05-22-2014 09:08 AM | |
| sauvincent | I replaced my Tie Rod ends today and it only took me about an hour! Thanks so much for the tutorial link. |
| 04-28-2011 11:23 PM | |
| tripplec |
Quote:
Originally Posted by zackman
View Post
i havent been able to find aftermarket control arms! thank you for this info!
I PM'd my info a week or so ago. They're a Canadian Company (Mevotech) with an office in Toronto. This make me more confortable and I like what I see. I used a ball joint of their's in my Grand Cherokee not long ago and it was great. |
| 04-28-2011 11:08 PM | |
| zackman |
Quote:
Originally Posted by tripplec
View Post
Maybe a good place to post for some local Canucks.
Mevotech makes quality control arms with ball joints and a newer high quality tie rod end (they have two on their site). I checked with my local part source and I can get both for under $200 which is in line or better than some US source and I don't need to deal with shipping etc. For those looking for better parts I would look at these. The tie rod end I look at has a grease fitting as well. |
| 04-22-2011 11:07 PM | |
| tripplec |
Maybe a good place to post for some local Canucks. Mevotech makes quality control arms with ball joints and a newer high quality tie rod end (they have two on their site). I checked with my local part source and I can get both for under $200 which is in line or better than some US source and I don't need to deal with shipping etc. For those looking for better parts I would look at these. The tie rod end I look at has a grease fitting as well. |
| 04-11-2011 03:25 PM | |
| Guinness |
Good DIY control arms/tie rod ends videos hey guys another member origanally posted these vids. i thought i would throw them in here bc they are a pretty good guide of how to check and replace outer tie rod ends and ball joints (control arms) vid for tie rod ends... http://www.youtube.com/watch?v=1YMtg6BWzwk&feature=fvsr vid for control arms... http://www.youtube.com/watch?v=wCyK3...feature=relmfu |
| Posting Rules | |