Power window issues - Jeep Compass Forum
 1Likes
  • 1 Post By kemayfield
 
LinkBack Thread Tools Search this Thread
post #1 of 4 Old 07-15-2014, 02:34 AM Thread Starter
Junior Member
 
Join Date: Jul 2014
Posts: 1
 
Power window issues

Sorry for my first post being needing help. I have a 2007 compass. The right front window will not roll up. I am a very experience auto collision tech (15 years). I did a quick test initially power to motor ok bad motor right..... The jeep says no. I have replaced motor regulator and switch on that door and still the same problem....... Angry face and such. Under more testing with meter on motor plug this time shows power and ground on down cycle but when shifted to up the ground goes dead. Any help or ideas would be greatly appreciated. Where are the other fuse/relay boxes located? Found the one under the hood.
Speedfreak636 is offline  
Sponsored Links
Advertisement
 
post #2 of 4 Old 07-15-2014, 02:32 PM
Senior Member
 
tripplec's Avatar
 
Join Date: Mar 2010
Location: Belleville, ON, Canada
Posts: 1,897
 
Make sure all you ground straps a clean and have good ground. Being a 2007 corrosion has been an issue on harness etc on these poorly engineer FIAT vehicles. Is it only that door that has this problem (other work and at the normal speed up/down?).

How are they controlling it? grounding the circuit to activate the motor or power to the motor with the ground always there on that wire? If its looks like the ground try running a ground to the motor from a good source and see if it works they you'll know.

PS: The TIPM controls all of these and other circuits. There buss connections may be corroded or poor.

Jeep Compass 2009
4x4, 2.4L, CVT
North Edition
heated seats, TPMS
General Altimax RT43 P225/65R17
Yellow Fog Lamps
CLASS III Curtis Hitch
SOLD @ 153,000km Oct. 2018 THE END !!
Belleville, Ontario, Canada

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
tripplec is offline  
post #3 of 4 Old 02-08-2016, 09:43 PM
Junior Member
 
Join Date: Feb 2016
Posts: 1
 
passenger power window won't go up.

had an issue with the passenger front window that would roll down under power but not roll up on a 2011 compass. Read everything i could find about what may be the problem. some said grounding issue... some said motor... one I read said they took it to a dealer and they disassembled it completely and checked grounds, switches, fuses, motors and everything else that it could be... they couldn't find anything... they put it back together and it worked. They didn't charge the customer (shocking) as they didn't do anything except take it apart and put it together. well I did the same thing. It would not roll up with either switch, on drivers door or passenger door. It is my understanding that the switches are wired in series. Therefore if the passenger door isn't making good contact, the drivers door switch wouldn't work either. anyway, i completely disassembled it and could not find anything wrong. so i hooked up the passenger door switch and shazam..... it worked like a champ. there had to be some corrosion on the connections of the plug. and taking it off and putting it on made connection again... that's my story and I'm sticking to it. At least it is fixed and it only cost me time.....
Snthespian likes this.
kemayfield is offline  
Sponsored Links
Advertisement
 
post #4 of 4 Old 11-12-2019, 04:40 AM
Junior Member
 
Join Date: Nov 2019
Posts: 1
 
I'm having an issue with my 2010 jeep compass last year early December when I go the jeep the passenger window went down and never went back up the dealership said that they would fix but was never able to connect with a good since I am a single mom and work during the open hours and only have one car. I have been driving the jeep with no passenger window, yesterday my driver window decided to do the same thing and is stuck down. The dealership was able to get the window up and disconnect the power to the passenger door window switch. It's cold and I need to get this issue fixed. Does anyone have any ideas on how to fix this issue? I am wanting to do this on my own if anyone could give me some ideas to try that would be great. The fuses are good and I have not checked the power to the switch to the motor and vic a vera but will do that tomorrow. So if that does not work anything else I can try?
tessaroo is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Jeep Compass Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools Search this Thread
Show Printable Version Show Printable Version
Email this Page Email this Page
Search this Thread:

Advanced Search



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome