Emergency brake
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Heat Only When Accelerating
Repairs - Mechanical problems and questionsFirst off - I have replaced the follow parts in the cooling system within the past few months: Heater core Thermostat housing (which came with both thermostats) Temp sensor Performed a full coolant flush with Prestone flush cleaner, distilled water, etc. & bled the system of air Filled it back...- 15
- 376
-
icer22x · updated
-
Crankshaft sensor
Repairs - Mechanical problems and questionsHi all, I have a 2011 compass latitude awd. I have had to bring it into the shop three times now because of the crankshaft code and it stalling out on me. They have replaced the sensor three times supposedly and it’s still doing it. Still sending the same error code. Any further suggestions...- 1
- 99
-
P0304 - Cylinder 4 misfire
Repairs - Mechanical problems and questionsI mainly get this error at idle (which makes me think vacuum leak), but I've swapped the plug, coil, and injector from another cylinder. Still getting the error on 4. Anybody have any luck with this code?- 7
- 249
-
icer22x · updated
-
Crankshaft Position Sensor Location!
Repairs - Mechanical problems and questionsI have a 2011 Jeep Compass that will not turn over. It cranks and tries to start but will not start, and I have come to find out that there is not any spark. I was told to try to change the crankshaft position sensor. I have searched and searched online but there is not much about these...- 4
- 16K
-
Synthetic Oil
Repairs - Mechanical problems and questionsI have a new 2020 Jeep Compass Latitude. I would like to switch to full synthetic. My Compass has a little under 200 miles on it (just bought it), and when would it be okay to change to synthetic? In other words, should I let the Jeep break-in with the factory oil?- 26
- 918
Join now to ask and comment!