My Jeep Compass Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1
hi ive seen the under front seat 10"s and the custom box where the BA sub is but i have 2 12s from my old car and i was trying to find some custom installs for this jeep(11 Compass) but i cannot so i was wondering if any one has does some glassing of the rear areas behind the tire wells and also has any one modded the doors to fit 8s in i see alot of the 6.5s but considering the BA system only sends lows to the front lowers i figured that 8s would be better suited
 

·
Registered
Joined
·
29 Posts
Discussion Starter #3
yes I have not even attempted to put my box in there it would take the entire cargo area .... i think I am gonna pull the panels in the back and glass a single layer there to see how much volume is there at the line where the spare hatch starts but it's -10°c so I will need to wait till the summer so I can actually air it out. I have seen some full door builds using 10s and supertweeters so I think there is enough area to do a 8" in the doors but I'm actually working on a trade for 4x alpine Rs for the sub box I have we will see if the guy actually buys them and brings them to me tho
 

·
Registered
Joined
·
17 Posts
I'm in the process of getting rid of my stereo setup and stepping down, what I have now is way too much for me, going to either install a skar audio evl-6.5 or a db drive wdx6.5, but I will be making a fiberglass box for the driver side behind the wheel well
 

·
Registered
Joined
·
29 Posts
Discussion Starter #5
didn't know db made a 6.5 but varified on the website nice looking sub for what it is. considering the jeep is open I don't know if I will do 2 12s again it really comes down to the volume I can get out of that area there but looking at it I think it would only be enough for a 10. I'm also that guy that likes to shake the car beside me lol but have main speakers that can still keep up with the amount of bass.
old car was 2x 12" RF punch subs @1000w rms
and the Rf fanatic 3 3way component set with a custom dash to get the 4inch mids in I was running the tweets from the head unit on these and then using a 4x 150rms amp to biam the 6.75 / 4" in the doors/dash ..... honestly tho I'm actually quite impressed with the BA system and only think it's lacking in the lows
 
1 - 6 of 6 Posts
Top