My Jeep Compass Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Hey all, currently have a 2010 Jeep compass North 4wd 5speed. I want to install a turbo on my 2.4L . Or either do an engine swap from possibly a Caliber with the turbo? Is that possible ? Could my drivetrain take the turbo? I do have an ACS stage 2 clutch, along with a new flywheel going into it. If i was to just get the turbo, would it go in without very much mods? Or am i better off just buying a 2.4 turbo, also, would it be a direct fit?

Thanks ya'll!~
 

·
Super Moderator
Joined
·
535 Posts
THe caliber SRT engine is not a direct swap. There have been limited (maybe 3 people) who have done turbo engine builds but its very cost prohibitive. If you have lots of money best bet would be to build up the engine you have. Trans will handle it as long as you don't abuse it
 
1 - 2 of 2 Posts
Top